Comparison of Hydrogen Generation Rate Between CORA-13 Test and MELCOR Simulation: Clad Solid-Phase Oxidation Models Using Self-Developed Code MYCOAC

To better understand the MELCOR oxidation and degradation models, past work compared the MELCOR model to a CORA experiment (CORA Test 13). These MELCOR analyses specifically focused on fuel bundle heatup and clad oxidation when compared to CORA test data. The comparison allowed the authors to investigate differences between hydrogen generation data and simulation results. Several potential reasons were considered for hydrogen generation rate differences, including MELCOR input power, heat transfer modeling, the clad solid-phase oxidation model, and the gaseous steam diffusion model. This work focuses on the possible uncertainty in the clad oxidation models used in MELCOR. First, the MELCOR nodalization approach for the CORA test was reviewed. Then, the temperature history and spatial variation were examined. One main focus was to consider other clad solid-phase oxidation models to compare the MELCOR models. This was accomplished by developing a separate model, MYCOAC, using MELCOR temperature predictions as input. Finally, the mass transfer resistance of steam diffusion to the clad surface was examined and found to be a small effect. While the Baker-Just solid-phase oxidation model showed better agreement with CORA data at low temperatures, the conclusion in this paper is that the oxidation models are not the major source of uncertainty in hydrogen generation rate differences. Future work will focus on heat transfer modeling of the CORA test.